|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|||
|
|
|
|
|
|
Pre-drill a hole slightly larger than the screw to be used. Place Trellis Spacer between support wall and Trellis. Screw to support wall. |
|
|
|
|
|
|
|
|
|
|
|
|
|
Lattice Installation | Cap & Divider Molding Installation | Important Things to Remember
Pre-drill a hole slightly larger than the screw to be
used. Place Trellis Spacer between support wall and Trellis. Screw to
support wall.
1. Pre-drill oversized holes and do not tighten
all the way to allow for expansion/contraction
2. Hang the lattice to install. Hang the lattice
with a support every two feet. Attach sides and bottom loosely. (Do not
tighten all the way.)
3. If using more than one panel, do not butt panels together.
Leave a 1/4" gap (6,35 mm) to allow for expansion/contraction.
1. Pre-drill oversized holes and do not tighten all the way to
allow for expansion/contraction.
2. Along the top drill and fasten every two feet (61 cm). Drill
holes and hang through both molding and lattice.
3. Along the sides and bottom, drill holes and put screws through
the molding only.
4. Allow a 1/4" gap (6,35 mm) on all sides of panel for expansion
with Cap and Divider Moldings.
Use
Classic moldings with Classic lattice.
Under decks, install wooden blocks or stakes as support points if none
are available.
If the lattice bows, loosen attaching screws, make sure you've allowed enough gap for expansion and reattach.
Place fasteners 24" (61 cm) apart.